Premier Nordic inverter
PREMIER has special and eye catching design that suits for every interior. Faultless reliability under harsh and cold outdoor temperatures makes this heat pump perfect heat source for your home. Indoor unit low noise level allows this unit to be installed even in the bedroom. Premier has built in a Nordic winter equipment, that allows effective defrost process control. All these features make this heat pump one of the best solution for heating on the market.
- Thin & Slim Design and Sleek Appearance
Flat design matches to various interior. Real aluminium panel.
- DC Inverter 180° Sine Wave technology
Energy saving operation is realized by latest sinewave 180 technology implemented by Midea R&D department. Compared to 120°Square Wave DC Inverter driving technology, the new 180° Sine Wave DC inverter driving technology has considerable advantages:
1. Appliable much wider range of frequency and voltage
2. More efficient and energy saving
3. Smooth running, low noise and vibration
4. More reliable in operation
- High COP & Powerful Heating Stable and energy efficient heating performance is guaranteed even at -25C outdoor temperature.
- Super DC Inverter
Besides the compressor, both of the indoor and outdoor fan motors are brushless DC inverter type. Owing to the function of DC inverter motors, full DC heatpumps gain higher efficiency and make quieter operation which helps to save more energy and enhance comfort to consumers.
- Industry highest energy efficiency
Spending each kW of electrical power You are getting over 5kW of heat from the outside air.
- Environmentally friendly refrigerant
The R410A eco-friendly refrigerant gas saves money and environment. It has a zero Ozone Depleting Potential and operates more efficiently, offering a 35% greater heat transfer rate.
- Low noise Airflow System
Without decreasing the airflow volume and capacity output, large diameter cross flow fan can bring down the indoor unit noise level by lowering the fan speed.
Product all Features:
Stable and energy efficient heating performance is guaranteed even at -25C outdoor temperature.
The materials used in the heat pump are designed to withstand the harsh Nordic climate.
Optimized defrosting logic, improved condensate evacuation, software controlled drain pan heater provide stable and reliable heating output in any weather conditions.
Special coating of outdoor unit heat exchanger guarantees efficient heat transfer properties of the coil for an extended time while standard coils progressively lose efficiency due to surface corrosion. This type of heat exchanges is perfect for areas suffering from high levels of pollution or near the ocean or salt spray.
+8C heating function also known as a holiday function is widely used in summer cottages where keeping normal indoor temperature is not reasonable. Holiday function provides continuous low-temperature heating to protect your home and furniture from frost damage, during the period when rooms are not being occupied.
GSM control option provides convinient control of Your heat pump through any GSM phone. No additional software is required.
Intelligent standby technology enables Midea products automatically enter energy-saving mode when standby, cut energy consumption from normal 4-5W to 1W which counts 80% of saving. NB! When outdoor temperature drops below +5C, additional power consumption of bottom tray heater must be taken into account.
With this technology, a temperature sensor is built in the remote controll. If you keep remote controller close to You, the unit will automatically adjust performance to supply comfortable temperature just like the air conditioner is following you.
Based on different installation height of indoor unit, the temperature deviation of the sensor sensed against the actual floor temperature always is different. Changing the jumping wires combination on the indoor PCB is possible to compensate the deviation. This could be achieved by installer in the installation field.
When you start the unit next time, the angle of horizontal louver will automatically move to the same position as you set last time.
Anions, always be found in forest or beside waterfall, can stimulate the blood circulation system in people’s body,improve lung function and effectively prevent respiratory passage illnesses (such as asthma and pneumonia).
Formaldehyde filter filters out formaldehyde and other volatile organic compounds (VOCs) as well as harmful gases and odors. It brings you healthy air always.
When this function is activated, firstly the indoor unit operates as cooling mode with low fan speed, during this period the condensed water will take some dust on evaporator fins away. After that the unit turns to heating operation with low fan speed, which drys the inside of indoor unit. Finally it turns to fan-only mode and blows away the wet air. The whole process cleans the internal side of indoor unit and prevents the breeding of bacteria.